RMS Mills Patented Dual Motor Drive System

This superior drive system solves many all too common problems with conventional V-belt drives:

A. Allows zero belt slippage;
--- Old style V-Belt drives slip, stretch, and often fail.

B. Allows eliminating all idlers.
--- Idler pulleys have bearings to fail, can go out of alignment, and be cause for belt failure.

C. Allows for shorter roll shafts.
--- Helps prevent shaft breakage due to overhung V-belt loading on long drive shafts.

Features

• Roll Alignment System
  This patented innovation allows precision roll alignment in seconds, while eliminating the need to remove covers and belt guards.

  A feeler gauge or the awkward procedure of "crimping paper" is no longer required!

  The roll adjustment controls have built in roll stops to prevent the rolls from ever running together. These stops never need adjusting, as roll wear is compensated for automatically by the Roll Alignment System.

• Feed Roll
  A large diameter solid cast iron feed roll is standard equipment on the RMS Industrial Series Roller-Grinder.

  The feed roll can be slowed to a complete stop, thus shutting off the flow of grain to the mill for end of day shutdown.

• Remote Control Feed Roll System (Standard on all 12" diameter Industrial mills)
  Our remote control feed roll system includes our exclusive micro-computer controlled overload shutdown system, which continually and automatically maintains full motor load regardless of the desired grind or the grain condition such as test weight or moisture. In the event of an over-amperage condition the system will continue to slow down the feed roll until the amperage is once again at the preset value (full motor load).

  In a plug up situation in which the over-amperage condition cannot be corrected, the system will completely stop the feed roll and sound an alarm. A pre-wired control panel is included (Nema 12 dust-tight enclosure).

• Sample ports and Dust Problems
  Dust free sample ports are standard equipment.

  When the sample collection tube is withdrawn, a spring loaded trap door on the inside of the mill automatically closes against felt to insure a dust free seal.

RMS Roller-Grinder, Incorporated, 27116 Grummand Avenue, Tea, SD 57064. Tel: 888-283-9337; Fax: 605-368-2411.